Hubbardton Forge 346013 - Manual

Installation Instructions
G3
For Outdoor Fixtures 346013 & 346013F Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14940 Rev D
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Component Parts
Note: Fixture, Post and Cover Cap each sold separately.
A J Bolts
B Fixture post
C Washers (4)
D Split washers (4)
E 5/16 nuts (4) F Cover Cap (sold separately)
G Fixture
H Set screw
I
Rubber Strip
J Fixture Collar
To Install (Figures 1 & 2)
Caution: Be sure power is off at the main breaker box prior to installation.
Site Preparation
1. Run appropriate wiring to the site of the fixture, leaving enough excess wire to
reach the top of the post, plus 12 inches.
2. Pour flat and level concrete base with wiring emerging at the center. Insert J
bolts (A) so approximately 1" of the bolts are exposed above the concrete.
Position J bolts according to the supplied template. Allow concrete to cure
before installing fixture.
Installation
Note: Post may be cut to length as desired before installation begins.
1. Position post over J bolts allowing supply wire to run up though the post and
secure using washers (C), split washers (D) and nuts (E).
2. Place optional cover cap (sold separately) (F) over post to conceal mounting
hardware.
3. Connect fixture wires to supply wires using appropriate wire connectors (not
provided), black to black, white to white and bare copper or green to bare
copper or green. If fixture is wired with twin lead lamp cord, connect smooth
side of fixture wire to black and ridged side to white.
4. Install the rubber strip (I) centered on each inside wall of the fixture collar.
5. Place fixture (G) onto post carefully tucking all wiring down into post and
making sure no wires are pinched between the post and the fixture. Secure with
set screw (H) using a 1/8” hex key wrench (not supplied).
( Figure 1 )
(continued)