Hubbardton Forge 347288 - Manual

Installation Instructions
G17
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27224
Forged Vertical Bars Post and Pier Mounted 34-7278, 34-7288 & 34-7288F Page 1 of 1
Note: Fixture, Post and Cover Cap each sold separately
Component Parts
A Glass
B Fixture
C Fixture
Collar
D Set Screw
To Install
Caution: Be sure power is off at the main breaker box prior to
installation.
Note: Post may be cut to length as desired before installation begins.
1. Connect fixture wires to supply wires using appropriate wire
connectors (not provided), black to black, white to white and bare
copper or green to bare copper or green. If fixture is wired with
twin lead lamp cord, connect smooth side of fixture wire to black
and ridged side to white.
2. For 34-7288 (square post) only, install rubber adhesive strips
centered on each inside wall of the fixture collar (C).
3. Place fixture (C) onto post carefully tucking all wiring down into
post and making sure no wires are pinched between the post and
the fixture. Secure with set screw (D) using a 1/8” hex key wrench
(not supplied).
4. Install 150-watt max type ‘A’ light bulb and glass (A).
Note: The glass is mouth blown. Minor irregularities, including
being slightly out of square, are normal. It may be necessary to
turn the glass in relation to the fixture to achieve a good fit.
5. Restore electricity to breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.