Hubbardton Forge 345715 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30442
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Note: Fixture is suitable for mounting within 4ft of the ground.
Fixture, Post and Cover Cap each sold separately.
To Install Post (Figure 1)
Component Parts
A Inner Frame
D Rubber Pads (4)
E J Bolt (4)
F Post
G Flat Washer (4)
H Split Washer (4)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
Site Preparation
1. Run appropriate wiring to the site of the fixture, leaving
enough excess wire to reach the top of the post, plus 12
inches.
2. Pour flat and level concrete base with wiring emerging at
the center. Insert J bolts (E) so approximately 1" of the bolts
are exposed above the concrete. Position J bolts accord-
ing to the template on the last page of these instructions.
Allow concrete to cure before installing fixture.
Installation
Note: Post may be cut to desired height before installation.
1. Position post (F) over J bolts (E) allowing supply wire to
run up though the post and secure using flat washers (G),
split washers (H) and hex nuts (I).
2. Place cover cap (sold separately) (J) over post (F) to conceal
mounting hardware.
3. Attach the four rubber pads (D) to the inside of the inner
frame (A).
4. Connect fixture wires to supply wires using appropriate wire
connectors (not provided), black to black, white to white
and bare copper or green to bare copper or green.
G18
Modern Prairie Post-Mount 345715 Page 1 of 4
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Continued)
(Figure 1)
A
K
D
F
J
I
H
G
E
I Hex Nut (4)
J Cover Cap (optional)
K Set Screw