Hubbardton Forge 347521 - Manual

Assembly & Installation Instructions
G9
For Outdoor Ellipse Bollard 34-7521 & 34-7521F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21223 Rev A
To Install Fixture (Figure 1)
Component Parts
A Post
B Nipple
C Fixture
D Set
Screw
Caution: Be sure power is off at the main breaker box prior to installation.
Site Preparation
1. Run appropriate wiring to the site of the fixture.
2. Install a weather proof electrical box with a gasket cover that has a 1/2-14
NPSM threaded hole in the center (not included).
Installation
Note: Post may be cut to desired height before installation. Be sure to cut from the
non-threaded end of the post. Remove all sharp burrs.
1. Thread nipple (B) into threaded end of post (A).
2. Feed wires from fixture (C) through post (A) and out through nipple (B).
3. Place fixture (C) onto post (A) carefully tucking all wiring down into post and
making sure no wires are pinched between the post and the fixture. Secure
with set screw (D).
4. Thread post (A) into center hole of electrical box cover.
5. Connect fixture wires to supply wires using appropriate wire connectors (not
provided), black to black, white to white and bare copper or green to bare
copper or green. If fixture is wired with twin lead lamp cord, connect smooth
side of fixture wire to black and ridged side to white.
6. Attach electrical box cover to electrical box.
7. Refer to glass installation instructions on next page.
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.