Hubbardton Forge 356005 - Manual

Installation Instructions
A38
For Semi-Flush Mount Outdoor Fixtures 35-6005 & 35-6005F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14581 Rev A
To Install Fixture (Figure 1)
Component Parts
A Crossbar
B Ceiling
Bracket
C 8-32 Screw (2)
D Threaded Stud (2)
E Ground
Screw
F Fixture Canopy
G Knurled Balls (2)
Caution: Be sure power is off at the main breaker box prior to
installation
1. Carefully unpack the fixture from the carton.
2. Using two 8-32 screws (C), attach ceiling bracket (B) to
crossbar (A) so that outer threaded holes in the ceiling
bracket are aligned with outer oval slots in the crossbar.
3. Using two machine screws (not provided) fasten
crossbar (A) to the electric box using outer oval holes to
orient fixture to desired hanging position.
Note: A new electric box comes with screws. When replacing
an existing fixture, retain the screws for use with the new
fixture.
5. Start threaded studs (D) into holes at ends ceiling
bracket.
6. Using suitable wire connectors (not provided), connect
fixture wires to supply wires (white to white or ribbed)
and (black to black or smooth).
Run a pigtail lead from
crossbar ground screw (E) to the junction box and connect all
ground wires (bare copper or green to bare copper or
green).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
7. Align holes in fixture canopy (F) with studs (D) and push fixture
firmly to ceiling, making sure that no wires are pinched between
fixture canopy and ceiling. Fasten with
knurled balls (G).
8. Refer to instructions following for glass installation.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)