Hubbardton Forge 363003 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30657
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Complete Fixture Assembly (Figure 1)
Component Parts
A Lock Nut
B Crossbar
C Cupped Washer
D Ground Screw
E Threaded Stud (2)
F Nipple
G Wood Screws (4)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Thread studs (E) through appropriate holes in crossbar (B) to
match holes in canopy (H).
3. Thread the nipple (F) into the crossbar (B) and secure with
lock nut (A).
4. Thread canopy loop (I) onto nipple (F).
5. Attach one end of the chain (L) to the loop on fixture (M
6. Slide cover plate (J) and canopy (H) over chain (L) until they
rest against fixture top (N). ). Lace the wire through
every other link of the chain (L) to the end.
7. Fasten the chain (L) to the canopy loop (I). Slip wires
through the canopy loop (I) and nipple (F). Make sure to
provide enough slack in the wire to ensure weight of
fixture is supported by the chain.
8. Raise fixture to ceiling and using at least two wood screws
(G) attach cross bar (B) to a structural member in the
ceiling, centering the crossbar over the outlet box.
We've supplied wood screws with your fixture; however,
different materials and/or construction methods may require
different fasteners. If in doubt, contact a qualified electrician.
Alternatively the crossbar can be attached to the outlet box.
A359
Mason Chain-Hung Fixture 363001 & 363003 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
G
I
J
D
A
B
C
H Canopy
I Canopy Loop
J Cover Plate
K Knurl Ball (2)
L Chain
M Fixture
E
K
M
F
H
L