Hubbardton Forge 366016 - Manual

Installation Instructions
A103
For Chain-Hung Fixture 36-6016 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Install Fixture (Figure 1)
Component Parts
A Lock Nut
B Crossbar
C Threaded Stud (2)
D Nipple
E Wood Screws (4)
F Canopy
G Canopy Loop
H Cover Plate
I Knurl Ball (2)
J Chain
K Fixture
Loop
L Fixture Top
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19774
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in crossbar (B) to match holes
in canopy (F).
3. Thread the nipple (D) into the crossbar (B) and secure with lock nut (A).
4. Attach one end of the chain to the fixture loop (K). Lace the wire through
every other link of the chain (J) to the end.
5. Slide cover plate (H) and canopy (F) over chain (J) until they rest against
fixture top (L).
6. Fasten the chain to the canopy loop (G) and slip wires through the canopy
loop (G) and nipple (D). Make sure to provide enough slack in the wire
to ensure weight of fixture is supported by the chain.
7. Raise fixture to ceiling and using at least two wood screws (E) attach
cross bar (B) to a structural member in the ceiling, centering the crossbar
over the outlet box. We've supplied wood screws with your fixture;
however, different materials and/or construction methods may require
different fasteners. If in doubt, contact a qualified electrician. Do not
attach crossbar directly to outlet box.
8. Using suitable wire connectors (not provided) connect fixture wires to
supply wires (white to ribbed side of the fixture cord, black to smooth
side). Connect all ground wires to crossbar ground screw.
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
9. Slide canopy (F) and cover plate (H) over threaded studs (C) and push
firmly to ceiling, making sure that no wires are pinched between fixture
canopy and ceiling. Fasten with knurled balls (I). Be sure studs (C) are
fully seated in the knurled balls (I). (Figure 1)
10. Install glass (see instructions on next page).
11. Restore electricity at main breaker.
(continued)