Hubbardton Forge 843007 - Manual

Installation Instructions
F13
For Beacon Hall Paper Towel Holder 84-3007
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24304
To Install
Component Parts
A Paper Towel Holder
B Set Screw (2)
C Wall Mount Plate (2)
D Screws (4)
E Wall Anchors
(4)
1. Locate area paper towel holder (A) is going to be
mounted and mark center location.
2. Measure from center location 1 7/8” for center
location of first wall mount plate (C). From that
mark measure over 3 3/4" to locate center location
for second wall mount bracket (C).
3. Hold first wall mount plate (C) in location it is to
be mounted. With a pencil, mark the location of the
mounting holes in the wall mount plate (C) on the
wall behind. Do this for both wall mount plates
making sure the are straight and level from each other.
4. Put the wall mount plate down and drill 1/4"
holes in the locations marked on the wall if wall
anchors (E) are to be used.
If directly attaching
to a solid support the drilled hole is not
needed.
For holes using anchors, place the
tapered end of the anchors (E) into the holes and
gently tap them flush to the wall using a light
weight hammer.
5. Install screws (D) through wall mount plates (C)
and into each anchor (E). If anchors are not
needed the screws (D) can be installed
directly to the wall.
6. Loosen two set screws (B). Screws are shipped
installed.
7. Slip paper towel bar (A) onto wall mount plates
(C) so the top edge slips onto the angled tab and
sits flat against the wall.
8. Tighten set screws (B) on both sides of paper towel
holder (A) until against wall mount plates (C).
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS PRODUCT PROPERLY MAY RESULT IN PERSONAL INJURY
OR PROPERTY DAMAGE. We recommend installation by a qualified individual trained in the building trade.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
(Figure 2)
(Figure 1)