Aqua Leisure SIMPLE SET SA-3766 - Manual (Page 7)

-6-
Installation Instructions
1. Prior to set-up and installation of filter pump, you must first set up the
Simple-Set
TM
Pool and fill it completely with water, exactly following the
Simple-Set
TM
Pool Manual instructions for pool set-up.
2. For optimal filter pump performance, position the filter pump unit at
least 8 inches below the highest water level in the pool.
3. Keep the position of the filter pump unit at least 2 feet away from the
sidewall of the pool itself.
4. Place clean filter cartridge (P6) into the body of the filter pump (P8).
5. Make certain that the filter chamber rubber gasket (P5) is placed in seal
groove at top of filter pump body (P8).
6. Screw on filter chamber cover (P4) onto top of the body of filter pump
(P8) in a clockwise direction by hand until it is secure.
7. Connect one end of hose (P28) to Inlet (upper) port of pump using one
hoseclamp (P29).
8. Tighten hoseclamp securely with screwdriver.
9. Connect other end of hose (P28) lower protruding hose fixture on wall of
pool, using one hoseclamp (P29).
10. Tighten hoseclamp securely with screwdriver. (Be careful to stay away
from sidewall/liner when using screwdriver).
11. Connect one end of second hose (P28) to Outlet (lower) port of pump
using one hoseclamp (P29).
12. Tighten hoseclamp with screwdriver.
13. Connect other end of second hose (P28) to upper protruding hose fixture
on wall of pool, using one hoseclamp (P29).
14. Tighten hoseclamp securely with screwdriver.
15. Open both wall plug caps (P34) on the inside of the pool and plug in a
strainer (P35) for each.
16. Allow time for filter pump chamber to fill with water. Never operate the
filter pump dry.
17. Connect electrical power cord (P21) into a grounded receptacle protected
by a ground-fault circuit interrupter (GFCI). Please contact a qualified
electrician for verification purposes and/or installation of a GFCI
receptacle if necessary.