Swiftech MCX478 V - Manual

Copyright Swiftech 2002 – All rights reserved – Last revision date: 11-24-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769
E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com
Page 1
Packing list
Parts Qty Parts Qty
Heat Sink 1 80mm fan straight brackets - pre-installed 4
Spring clips 2 Snap-rivets (for fan installation) 4
92mm fan brackets 4 Thermal grease – Céramique 1
I. Heat sink Installation
1. The case should be laying flat on a table. Remove the existing heatsink.
2. Clean up the processor surface with alcohol, and lightly coat it with the provided Céramique  thermal compound. Detailed
instructions can be found at http://www.arcticsilver.com/ceramique_instructions.htm
3. The MCX478-V heatsink ships with 80mm fan brackets pre-installed. You will need to remove them, and install the included 92mm
brackets if you plan on using a 92mm fan. Use a thin screwdriver to remove and install the brackets, so as to not damage the
surrounding pins.
80mm fan straight bracket (as shipped) 92mm fan bracket
F a n
S n a p - r i v e t
S p r i n g C l i p
M C X 4 7 8 - V
h e a t s i n k
S t o c k r e t e n t i o n
f r a m e
C P U
M o t h e r b o a r d
AIRFLOW DIRECTION
Figure 1
Information subject to change without notice