Swiftech MCB 120 Radbox - Manual

1703, E. 28 th St, Signal Hill, CA 90755 USA – Tel. (562) 595-8009 – F 562-595-8769 – www.swiftnets.com
1 of 2
™
Parts list
Parts QTY PARTS QTY
MCB-120™ Housing assembly 1 Coolsleeves™ 20” (*)
Retention hardware (screws, etc..) 1 PCI Pass-Thru kit 1 (*)
½” tubing 2’ (*) Worm drive clamps 4 (*)
(*) only included with complete kit
1/ PCI pass-thru kit installation
o Insert the PCI bracket into an available opening, and secure it to the chassis.
o Insert your fan electrical connector through the slotted hole of the PCI bracket now. Only 3-pin
connectors (the type that connect to the motherboard) are small enough to pass through the
slotted hole. 4-pin Molex connectors (the type that connect to your power supply) will require that
the terminals be removed from the Molex housing first.
o From inside of the chassis, insert the pass-thru adapters through each hole of the PCI bracket.
The threaded portion of the adapters should be exposed outside of the case.
o Screw the nuts to the adapters. The nuts are designed to slightly overlap the edges of the PCI
chassis opening, to provide a more secure installation.
2/ Housing / fan & radiator installation: please refer to diagram page 2.