Swiftech MCW30 HARD MOUNT - Manual (Page 4)

Copyright Swiftech 2006 - All rights reserved - Last revision date: 4-20-07 - One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech - 3700 Industry ave., suite 104, Lakewood, CA 90712 - Tel. 562-595-8009 - Fax 562-595-8769 -
E Mail: [email protected] - URL: http://www.swiftech.com - Information subject to change without notice
ITEM NO. PART NUMBER DESCRIPTION QTY.
1 MCW30-base-plate 1
2 MCW30-HOUSING 1
3 4-40X5-16-SOCKET-92196A107 4
4 1-4-NPSMx3-8-barb
1/4" NPSM X 3/8"
Barb fitting
2
5 O-RING-9557K473
1-4'" NPSM barb
fitting O-Ring
2
6 O-RING-DASH124-9452K88 Body o-ring 1
7 intel-mount wire clip 2
4
5
7
3
1
2
6
INSTALLATION WITH HOOKS AND WIRE CLIPS
You can either leave the brackets providing that they do not
interfere with components on your motherboard, or you can
remove them. If you do remove the brackets, please use the pro-
vided 4-40 x 5/16” socket screws to reassemble the water-block.
•
Removal of the mother-
board is NOT necessary to
install the MCW30 in this config-
uration.
•
Remove the existing
heatsink
•
Clean off the CPU with a
degreaser, and spread some of
the included thermal compound
over it.
•
Install the MCW30 over
the CPU
•
Insert the hooks of the
wire clips 7 underneath the
loops of the motherboard.
•
Installation is now com-
plete
ALWAYS CHECK YOUR CIRCUIT FOR LEAKS PRIOR TO POWERING-UP YOUR COMPONENTS!
Fittings compatibility notes:
The provided fittings thread is 1/4” NPSM. This thread is compatible with BSPP and G 1/4 threads.
G ¼, or BSPP fittings will fit, but may not necessarily seal properly; each must be checked prior to assuming that it will not leak just
because they fit together. Both NPSM and G ¼ (BSPP) are parallel thread and nominally the same size, the principal difference
being 18 threads per inch for NPSM and 19 threads per inch for G ¼ (BSPP). Since most male end G ¼ fittings have a short
thread length they can generally be engaged in the NPSM threads without difficulty. The joint seal is effected with an o-ring which
for the NPSM barb is in a groove on the waterblock top and compressed by the flange nut barb. G ¼ fittings have the o-ring cap-
tured in a groove under the fitting nut. G ¼ fittings will seal so long as there is a straight portion under the nut flats sufficient to bring
the G ¼ fitting’s o-ring into contact with the bottom of the waterblock o-ring groove, a depth of 0.080”.