Swiftech APOGEE DRIVE II - Socket 775/1155/1366 User Manual
Page 4
Copyright Swiftech 2012
– All rights reserved – Last revision date: 5-29-12 - Rouchon Industries, Inc., dba Swiftech® –151 West Victoria Street, Long Beach, CA 90805 – Tel.
310-763-0336 - Toll free (US) 888-857-9438
– Fax 310-763-7095 - E Mail: [email protected] – URL: http://www.swiftech.com - Information subject to change without notice
Electrical Installation
Hydraulic Installation
Attach the tubes to the hose-barbs, and secure them with the provided hose-clamps. The water-block inlet is specific, and
indicated by
an “IN” marking on the side of the waterblock housing.
Alternate orientation of the inlet and/or outlet ports
The inlet and outlet ports are installed straight up by default. They can also be installed at an angle to facilitate tube
routing. To change the orientation of a port, loosen the 2 screws holding the port to the waterblock body and rotate the
port until the holes match those in the waterblock, and then re-insert the existing screws.
Caution!
Make sure that the port o-ring stays in place during installation!
To power supply