Swiftech MCW5002 64 User Manual
Parts list
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Parts list
Parts
QTY
PARTS
QTY
MCW5000-64™ assembly
1
Aluminum tension limiter
2
6-32 x 1 ¾ Philips screw
2
Springs
2
Nylon shoulder washers
2
Arctic Alumina Thermal compound
1
Tube inserts
4
Nylon spacers
2
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in
damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their
installation. The following instructions are subject to change without notice. Please visit our web site at
updates.
1.
Before you install the MCW5000-64™ water-block:
a. Prepare two pieces of tubing of sufficient length to connect
to the rest of your circuit. The cuts must be square as shown in
figure 1 or leaks may occur:
b. Install the provided plastic tube inserts at each end of the tubes,
as shown in figure 2: these inserts are absolutely imperative when
using any kind of soft tubing, such as vynil, ClearFlex, Taigon, etc...
Square cut
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
c. Spread a little bit of grease or simple
liquid soap around the tubing. It helps pushing
the tubes in, particularly with Clearflex
tubing,
which features a very “sticky” surface.
d. Fully insert both tubes into the fittings. The tip of the plastic tube inserts should
be flush with the inlet and outlet openings, as shown in figure 4 above. Inserting the
tubes requires a firm push, accompanied by a twisting motion.
2.
Preparing your Motherboard
Remove the existing heat sink
Carefully clean the CPU.
Lightly coat the CPU with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied
using preferably a razor blade, or a credit card, held between thumb and index at a 45-degree angle.
3.
MCW5000-64™ water-block installation diagram
Method 1: The MCW5000-64 water-block bolts onto AMD’s validated plastic retention frame with two screw
spring assemblies. Please use the retention frame provided by your motherboard vendor. Remove the two
existing screws that hold the frame in place, place the water-block assembly onto the CPU, and use these two
holes to bolt down the spring assemblies, as shown in figure 6, page 2. Each spring assembly features an
aluminum spacer acting as a tension limiter. It’s main purpose is to guarantee that each springs is compressed
to the exact same amount of tension (35lbs each).
Method 2: It is also possible to install the MCW5000-64 without the stock plastic retention frame.
However, you MUST then use the nylon spacers provided with your accessories package as shown in figure 7,
page 2. These are necessary to replace the stock plastic retention frame and to provide support to the entire
assembly.
Page 1 of 2