Swiftech MCW5002 64T User Manual
Page 5
b. Connecting to your computer power supply:
Important Warning: to connect the MCW5002-64T
cooler to an
ATX computer power supply, you must carefully consider the
existing requirements of other devices connected on the +12V line.
Connecting to an underpowered unit will definitely damage the
power supply.
Minimum requirements for an ATX computer power supply: 36A at
+12V in a typical computer setup.
When you connect the MCW5002-64T
to an ATX power supply,
you need to cut the wiring to one of the power supply Molex
connectors, and use a different connector between power supply,
and thermoelectric. This is because Molex connectors are not rated
for 18Amps current, and may overheat.
c.
Connecting TEC wires to the power supply:
Use the provided euro-style wire connector as shown in fig 11
below, or a similar device with a current rating of at least 25 amps.
Connect red wire from TEC module to +12V of P/S (Yellow wire),
and black wire to black wire:
Figure 11
If you need wiring extensions: use 16 gage stranded wire. Connect
the extension to the existing wires with terminal splices, or solder the
butts, and insulate with shrink tubing.
d. Hydraulic Installation
The MCW5002-64T is shipped with ½” barb to 3/8” NPT nylon fittings. These fittings should be installed using Teflon tape or
plumbers “goop”. If fittings need to be replaced for a difference tubing size, do not use brass fittings, because of the galvanic
corrosion that will take place between copper or brass and the MCW5002-64T aluminum housing. Always use nylon fittings.
Inlet and outlet are interchangeable.
Type of Coolant:
For best performance, use 95% distilled water, and 5% Swiftech brand “HydrX” corrosion inhibitor (available here:
“accessories” section).
In all cases, you must use Distilled water and a corrosion inhibitor with the MCW5002 water-block. Regular automotive
anti-freeze is acceptable. Automotive manufacturers recommend that not less than 25% is used.
NEVER use tap water, even for a short-term test.
Not following the above instructions constitutes misuse (*) of the product, and will void your warranty.
4. Final inspection
Once the installation is completed, it is always a good idea to test the circuit for leaks, prior to powering up the computer. Troubleshooting help is
available on our web site at
by calling customer support at 562-595-8009.
IMPORTANT DISCLOSURES
While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech assumes no liability expressed or implied for any
damage(s) occurring to your components as a result of using Swiftech cooling products, either due to mistake or omission on our part in the above
instructions, or due to failure or defect in the Swiftech cooling products.
WARRANTY
Our products are guaranteed for 12 months from the date of delivery to the final user against defects in materials or workmanship. During this period,
they will be repaired or have parts replaced provided that: (I) the product is returned to the agent from which it was purchased; (II) the product has
been purchased by the end user and not used for hire purposes; (III) the product has not been misused
(*)
, handled carelessly, or other than in
accordance with any instructions provided with respect to its use. This guarantee does not confer rights other than those expressly set out above and
does not cover any claims for consequential loss or damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as a
consumer.
Page 5 of 5 - Created 7-10-04 - Copyright
Swiftech – All rights reserved – Subject to change without notice