Swiftech MCW6000 2 P - Manual

1. Preparing your Motherboard
Remove the existing heat sink and carefully clean the CPU.
Apply thermal compound: lightly coat the CPU with the provided Céramique™ thermal compound. Follow this link
http://www.arcticsilver.com/ceramique_instructions.htm for detailed instructions.
Rub some compound in base of water-
block first, and then clean off with lint-
free cloth
Apply small amount of
compound on the CPU heat
spreader
2. Water-block orientation
For ease of operations during bleeding, the outlet should always be at the highest point (while system is standing upright):
Parts list
Parts QTY PARTS QTY
MCW6000 or 6002-P™ water-block 1 Retention clips 2
Worm drive clamps 2 SP4 hold-down plate 1
Céramique thermal compound 1
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation
may result in damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of
these products, nor their installation. The following instructions are subject to change without notice. Please visit our web
site at
www.swiftnets.com for updates.
b
ITEM NO. QTY. PART NO. DESCRIPTION
1 1 S478 Intel Pentium 4 socket 478 motherboard and processor
2 1 MCW6000-P-with-bracket MCW6000-P water-block assembly
a 1 MCW6000-FLAT MCW6000 waterblock flat base
1 SP4-Bckt SP4 Hold-down plate for Intel Pentium 4 and Xeon
3 2 SC478 Pentium 4 spring clip
3
1
INLET
DISCHARGE
Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E
Mail: [email protected] – URL: http://www.swiftnets.com - Information subject to change without notice