Swiftech MCW50 T - Manual

Swiftech Inc., 1703 E. 28 th St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Installation guide
Parts QTY PARTS QTY
MCW50-T™ thermoelectric assembly 1 4-40 x 1 /14 Philips (pre-installed) 2
Nvidia  hardware Spring 2
2-56 S/S socket screw 4 Nylon screw spacer 2
Nylon screw spacer 4 Nylon retaining washer 2
Spring 4 Nylon nut 2
Nylon washer 4 Miscellaneous
Hex L-key 5/64” 1 Tube insert 4
Hex L-key 3/32” 1 Back-of-board gasket 1
ATI  Hardware Thermal compound 1
This product is intended for expert users only. Please consult with a qualified technician for installation. Improper installation may result in
damage to your components. Swiftech™ assumes no liability whatsoever, expressed or implied, for the use of these products, nor their
installation. The following instructions are subject to change without notice. Please visit our web site at
www.swiftnets.com for updates.
Installation
diagram
MCW50-T for
nVidia Gforce 
 
4-40x1/4“ socket screws need to be installed for nVidia products 
Nylon washer
Spring
Nylon screw spacer
2-56 s/s socket screw
Figure 1
MCW50 for
ATI Radeon 
 
Nylon retaining washer
Spring
Nylon screw spacer
Nylon hex nut
AS SHIPPED 4-40 x 1.25“
Phillips
Figure 2
MCW50-TFX
The new MCW50-TFX installs pretty like the Radeon version, except that the mounting posts are reversed, and springs are bolted from the top of the
card, instead of from the backside of the card. See separate installation schematic for details, page 4.
MCW50-T: 12-15-03 Page 1 of 4