Swiftech MCW60 R2 User Manual
Page 3
Copyright Swiftech 2006 - All rights reserved - Last revision date: 05-09-06 - One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech - 1703 E. 28th Street, Signal Hill, CA 90755 - Tel. 562-595-8009 - Fax 562-595-8769 -
E Mail: [email protected] - URL: http://www.swiftnets.com - Information subject to change without notice
Installation with nVidia GeForce 6800 to 7900 series
& ATI X1800 and above
(four mounting holes)
ITEM NO.
PART NUMBER
DESCRIPTION
QTY
.
1
MCW60
WATER-BLOCK
1
2
1-4-NPSMx3-8-barb
1/4" NPSM X 3/8" Barb fitting
2
3
MCW60-HDP-R2
MCW60 HOLD-DOWN PLATE R2
1
4
MCW60-CB-R2
MCW60 CROSS-BRACKET R2
1
5
MCW60-2-56-PFH-CS
2-56 CUSTOM SCREW
4
6
REFERENCE
VGA ADAPTER
1
1
3
2
6
4
5
•
Remove the existing heatsink
•
Clean off the GPU with a degreaser, and spread some of the included thermal compound over it.
•
Position the MCW60 over the GPU, aligning the 4 feet of the hold-down plate to the circuit board thru-holes
•
Insert screws #5 thru cross-bracket #4, thru the circuit board, and fasten them into the legs of hold-down plate #3,
tightening the screws gradually and in a cross pattern.
•
Installation of the water-block is now complete