Swiftech MCW60 T User Manual
Page 5
Step 7
Step 8
Push the gasket down the posts until it mates with the board and
then remove the peel-off paper
Push the MCW60-T assembly down the posts until it
mates with the GPU
Step 9
Step 10
Place the spring, nylon tension limiter and thumbnuts on each
post.
Gradually fasten the thumbnuts until you feel that the
nylon tension limiter is preventing the spring from
compressing further. Do not over tighten!
Mechanical installation is now complete!
4.
Electrical Installation
IMPORTANT WARNING: Solder joints of the wires to the thermoelectric module are extremely fragile. Bending the
wires at their root will break the solder joint, with no possible repair. Swiftech will not honor the warranty for broken
wires.
Thermo-electric modules characteristics:
The Peltier module used with your MCW60-T can be safely operated from 12 to 19.3 Volts.
Copyright Swiftech 2006 – All rights reserved – Last revision date: 5-15-06 – One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:
[email protected] – URL:
http://www.swiftnets.com
- Information subject to change without notice