Swiftech H20 120 PREMIUM2 User Manual
Page 9
Copyright Swiftech 2007 – All rights reserved – Last revision date: 1-15-07 - Information subject to change without notice – URL:
http://www.swiftech.com
Rouchon Industries, Inc., dba Swiftech – 3400 Industry ave., suite 104, Lakewood, CA 90712 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 9 of 28
A. Securing the base plate at the desired location:
B. Housing/Fan/Radiator installation
Once you have found a satisfactory position for the Radbox base plate, secure the housing and fan to the radiator
using the provided (4) M3.5 x 30mm Philips screws. Ensure that the exit of the fan wire is positioned towards the
bottom of the PC and to its left (towards the motherboard) to facilitate further routing of the wire through the PCI
pass-thru.
C. Finalizing the installation
Secure the housing/fan/radiator assembly to the base plate with the provided #4 screws. With the radiator in its
final place, you can now cut two pieces of tubing of sufficient length to connect inlet and outlet of the radiator to
the PCI pass-thru nipples. The tubes will form some sharp bends here, and you must wrap them with the provided
Smartcoils by forming tight loops in order to prevent the tubes from kinking. Please refer to the Smartcoils
installation in the following chapter for further details on how to use Smartcoils. Once done slip the tubes over
their respective fittings, and secure them with the provided hose clamps.
D. Electrical connection
The fan shipped with the MCR120 uses a 3-pin connector. For 12volt operations, this connector can be safely
installed on one of the motherboard headers. Use any free header other than the CPU fan header, since the
pump RPM sensor will be connected to the CPU fan header in order to monitor the pump.
For low noise operations, 2 additional fan connector adapters are supplied with the kit, and should be connected
to the power supply instead of a motherboard fan header:
12v to 7v adapter: this setting provides a good balance for performance, at whisper quiet
operations
12v to 5v adapter: this setting is for silent operations, and will result in higher processor
temperatures.
Please consult the product page (
www.swiftnets.com/products/h20-120-premiunm.asp
) on our
web site for specific data with respect to CPU temperatures when using the 12 to 7V or 12 to 5V
adapters.
Your radiator installation is complete, and we can now move on to the water-block installation.