Swiftech H20 120 R2 - Manual (Page 9)

8. Final installation
Once your system has been tested for leaks, it is now time to proceed with the final installation. Assuming that you followed our preferred
method , re-install the motherboard inside of the chassis, being careful to keep the water-blocks out of the way (some wire-ties or rubber
bands strategically placed are a good help). Then perform the final water-block installation using thermal grease, in accordance with your
specific water-block model installation guide (see appendix).
Figure 6
Figure 6 above illustrates an installation using the MCRES-525 reservoir, MCP650 pump, MCW6000-A water-block, MCW20 chipset cooler,
MCW50 VGA cooler, and MCR120 radiator mounted externally with the MCB-120 “Radbox”
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28 th St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All content
Copyright Swiftech 2004 – Last edited 9-27-04 – Subject to revision without notice - 9 of 40 -