Mcres-1000p assembly installation – Swiftech H20 120 R3A User Manual
Page 10
Copyright Swiftech 2005 – All rights reserved – Last revision date: 7-28-05 - Information subject to change without notice – URL:
http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 10 of 38
4. MCRES-1000P
ASSEMBLY INSTALLATION
Introduction
The radiator inlet and outlet spigots must be oriented upwards during the filling procedure.
Proceed deliberately and frequently check your work. Rushing this procedure is not recommended
.
Two methods can be used to fill-up the reservoir:
Preferred: whenever possible, the reservoir should be filled before placing it in the CD-Rom bay. This is the easiest and safest
method, described in paragraph A below.
Alternate: If your chassis configuration necessitates that the reservoir be installed in the CD-Rom bay prior to filling, please refer to
paragraph B “Alternate Filling Method”.
Preparing the HydrX coolant
Your kit comes with a 2 Oz (60ml) bottle of Swiftech’s specially formulated HydrX
concentrated coolant. The product should be mixed with
distilled or demineralized water only. Simply empty the concentrated coolant into a 33 fl oz (1 liter) plastic bottle, and complete filling with
distilled water. Your coolant is now ready.
A) F
IRST TIME INSTALLATION AND PREFERRED FILLING PROCEDURE
Step 1.
Cutting the tubes to length: position the MCRES-1000 in the
desired CD-Rom drive bay, and cut sufficient length of tubing in order to
allow the assembly to slide back as shown above for periodic maintenance
purposes.
Step 2.
Connect the discharge tube to the pump (coming from either
CPU inlet, or radiator for example), and the return line to the reservoir
inlet barb. Secure the tubes with the provided worm-drive clamps.
Tighten quite firmly, but not excessively as it may result in crushing the
plastic barbs.
Step 3
. Rest the MCRES-1000P assembly on a paper towel or cloth on
top of the computer. Using a household funnel, fill-up the reservoir with
cooling fluid - slowly to avoid overflowing, until the fluid reaches the
appropriate level --------------
3. Appropriate level: up to the vent hole.