Swiftech H20 APEX - Manual (Page 17)

Copyright Swiftech 2005 – All rights reserved – Last revision date: 4-16-05 - Information subject to change without notice – URL: http://www.swiftnets.com
6. MCRES-M ICRO RESERVOIR I NSTALLATION
ITEM
NO.
PART NUMBER DESCRIPTION QTY.
1 MCRES-MICRO Reservoir 1
2 1-4“ NPSM x 3-8“ and 1-2“barb Barb fitting
2 pairs
each
3 O-RING-9557K473 Barb fitting O-Ring 2
4 pg7-o-ring Fill-cap o-ring 1
5 pg7-plug Pg7 Fill-cap 1
6 MOUNTING HARDWARE 3
90272A152-6-32x0500philips 6-32 x 7/8" (22mm) Philips screw 1
90760A007 6-32 Nut 1
washer-91007A614 Lock Washer 1
WASHER-RUBBER-437X150X092 Rubber Washer 1
7 panel 1
6a
6b
6c
6d
Installation
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28 th Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 17 of 20
• The MCRES-MICRO can be installed in any suitable location meeting its form factor requirements. For filling and
bleeding purposes, it is preferable to hold or to install the MCRES-MICRO at the highest point of the liquid cooling
loop. However, once filled and hermetically closed, the reservoir can be installed practically anywhere as long as it is
kept upright as shown in figure 1. Also, to facilitate the filling and bleeding operations, you might want to wait until the
circuit has been filled-up before you fasten the reservoir permanently to the chassis.