Aiwa XP-EV501R - Manual

C
Portable CD Player
Operating Instructions
3-252-374-21 (1)
WARNING
To prevent fire or shock hazard, do not expose the unit to
rain or moisture.
Do not install the appliance in a confined space, such as
a bookcase or built-in cabinet.
To prevent fire, do not cover the ventilation of the
apparatus with newspapers, tablecloths, curtains, etc. And
don’t place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects filled
with liquids, such as vases, on the apparatus.
CAUTION
The use of optical instruments with this product will
increase eye hazard.
Certain countries may regulate disposal of the battery used
to power this product. Please consult with your local
authority.
CAUTION
• INVISIBLE LASER RADIATION WHEN OPEN
• DO NOT STARE INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENT
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the
countries EEA (European Economic Area).
Owner’s Record
The model number and the serial number are located at the
rear of the CD player. Record these numbers in the spaces
provided below. Refer to them whenever you call upon
your Aiwa dealer regarding this product.
Model No. _____________________________________
Serial No. ______________________________________
For the customers in the USA
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
– Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
Power Sources
To use the batteries (B)
Use only the following batteries for your CD player:
Dry batteries
• LR6 (size AA) alkaline batteries (not supplied)
Rechargeable batteries
Charge the rechargeable batteries before using them for
the first time.
• Commercially-available size AA Ni-MH rechargeable
batteries of 1.2 V DC, 700 mAh
To insert the batteries
1 Open the battery compartment lid on the rear of your CD
player.
2 Insert two batteries by matching the ) to the diagram
in the battery compartment and close the lid until it
clicks into place.
3 When using the rechargeable batteries, connect AC
power adaptor (not supplied) to the DC IN 4.5V jack
of your CD player and an AC outlet, then press s/
OFF/CHARGE to start charging.
The CD player charges the batteries. The “CHG”
indicator turns on in the display and the indicator
sections of
light up in succession. When the
batteries are completely charged, the “CHG” and
indicators get turned off.
If you press s/OFF/CHARGE after the charge has
already been completed, the
indicator flashes
and “Full” appears in the display.
4 Disconnect the AC power adaptor.
Battery life* (approx. hours)
(When the CD player is used on a flat and stable place.)
Playing time varies depending on how the CD player is used.
CD player (front)
CD player (rear/inside)
Remote control (XP-EV501R only)
Note
Use only the supplied remote control. You cannot operate this
CD player with the remote control supplied with other CD
players.
Display
D
*The button has a tactile dot.
XP-EV501R/EV501C
Sony Corporation ©2003 Printed in China
Notes
• The indicator sections of roughly shows the
remaining battery power. One section does not always
indicate one-fourth of the battery power.
• Depending on operating conditions, the indicator
sections of may increase or decrease.
Notes on using the dry batteries
• Be sure to remove the AC power adaptor.
• When the batteries are depleted, replace both batteries
with new ones.
To use the AC power adaptor (C)
1 Connect the AC power adaptor (not supplied) to an
AC outlet.
Playing a CD
To insert a CD
1
Slide OPEN to open the lid (A).
2 Fit the CD to the pivot, then close the lid (D).
Notes
• This CD player can play discs recorded in the Compact
Disc Digital Audio (Audio CD) format.
• This CD player can play CD-Rs/CD-RWs recorded in the
Compact Disc Digital Audio (Audio CD) format, but
playback capability may vary depending on the quality of
the disc and the condition of the recording device.
• This product is designed to play back discs that conform
to the Compact Disc (CD) standard. Recently, various
music discs encoded with copyright protection
technologies are marketed by some record companies.
Please be aware that among those discs, there are some
that do not conform to the CD standard and may not be
playable by this product.
To operate the CD player
A
B
E
The illustrations below show the model XP-EV501R.
E•A•S•S
ON
OFF
Two Sony alkaline 50 40
batteries LR6 (SG)
(produced in Japan)
* Measured value by the standard of JEITA (Japan
Electronics and Information Technology Industries
Association).
To check the remaining power of the
batteries
You can check it in the display.
Replace the batteries when “
” flashes.
Lo batt*
* Beep sounds only when the CD player is set to sounds beep.
See “To turn off the operation beep sound” on the reverse
side.
Button/Switch
1 P-MODE/
(play mode/repeat)
2 SOUND
3 r/t
(B SKIP/F SKIP)
(skip/search)
4 ca(play/pause)/
ENTER
5 s(stop)/OFF/
CHARGE(s)
6 HOLD
7 VOL+/–
8 E•A•S•S* 2
* 1 If the sound is distorted when using the SOUND function,
turn down the volume.
* 2 E•A•S•S = Electronic Anti-Shock System
* 3 Sound may skip:
– if the CD player receives stronger continuous shock than
expected,
– if a dirty or scratched CD is played or
– when using poor-quality CD-Rs/CD-RWs or if there is a
problem with the recording device or application software.
To remove the CD
Remove the CD while pressing the pivot (E).
(Continue to the reverse side)
Function/Operation
Press repeatedly until the play
mode you want appears in the
display.
No indication: Normal play
“1”: Single play
“SHUF”: Shuffle play
“PGM”: PGM (program) play
To repeat the play mode you
selected, press and hold until
“
” appears. To cancel it, press
and hold again until “ ”
disappears.
Use to emphasize the bass-boosted
sound. Press repeatedly to select
or .
enhances more than
.* 1
Press r or t once to find
the beginning of the current/next
track. Press r or t
repeatedly to find the beginning of
the previous/succeeding tracks.
Press and hold r or t to go
backward/forward quickly.
Press to start playing. Press again
to pause playing.
To play from the first track, press
for 2 seconds or more while the
CD player is stopped.
Press to enter the selected track
for the PGM play.
Press to stop playing. Press also to
start charging.
Use to lock the controls on your
CD player or remote control to
prevent accidental button presses.
HOLD on the CD player works
only for the player, while HOLD
on the remote control works only
for the remote control.
Press (slide for the remote control)
to adjust the volume.
Set to ON to protect against sound
skipping.*
3
http://www.aiwa.com/
2SOUND
\ (headphones)
jack
6HOLD
DC IN 4.5 V
(external power
input) jack
7VOL +*/–
5s(stop)/OFF/
CHARGE
Display
1P-MODE/
Strap holes
4ca* (play/
pause)/ENTER
3r/t
(skip/search)
OPEN
8E•A•S•S
Insert the ( end first (for both
batteries). Open the battery
compartment lid.
Play mode
Track number Playing time
Remaining battery power
Sound mode
CHG
to an AC outlet
\
AC power
adaptor (not
supplied)
Headphones
DC IN
4.5 V
Label side up
4ca
7VOL
Headphones
jack
3tF SKIP
3rB SKIP
2SOUND
6HOLD
5s