Swiftech MCR X20 DRIVE REV2 - Manual (Page 5)

Copyright Swiftech® 2010 – All rights reserved – Last revision date: 8-27-10 – One or more Patents Pending - Rouchon Industries, Inc., dba Swiftech® –151 West Victoria
St., Long Beach, CA 90805 – Toll free (US) 888-857-9438 – Tel. (310) 763-0336, Fax (310) 763-7095 - E Mail: [email protected] – URL: http://www.swiftech.com -
Information subject to change without notice
b/ Operating precautions:
The MCP35X pump should never be run dry, even for a quick test . You should always prime the pump by filling-up the MCR Drive radiator with
fluid before you start operating it (see warranty note *).
Use of coloring die or fluorescent additives containing particulate fillers will cause excessive wear to the pump’s impeller bearing (see warranty
note **).
c/ Specifications:
Motor type Electronically commutated, brushless DC, spherical motor
Nominal voltage 12 V DC
Operating voltage range 9 to 13.4 VDC
Max. nominal power (@12 V) 18 W
Max. nominal current (@12 V) 1.5 A
Max. nominal head (@12 V) 14.7 ft (4.4m)
Max nominal discharge (@12 V) Max nominal discharge (@12 V)
Maximum pressure 22 PSI (1.5 BAR)
Temperature range Up to 140°F (60°C)
Electrical power connector Molex 4 pin
PWM + RPM signals 4-pin connector
ROHS Compliant
Port thread standard 1/4
MTBF (Mean Time Between Failures) 50,000 Hours
WARRANTY: This product is guaranteed for a period of 24 months from date of purchase for defects in material, and workmanship. Guarantee
consists of replacing defective parts with new or reconditioned parts. Guarantee is considered void in case of improper use (*)(**), handling or
negligence on the part of user. Original invoice showing date and place of purchase is required for exercise of the warranty.
(*) WARNING: DO NOT
ATTEMPT TO RUN THIS PUMP DRY. THIS WILL CAUSE IMMEDIATE AND PERMANENT DAMAGE TO THE PUMP. (**) EXCESSIVE WEAR DUE TO
INNAPROPRIATE FLUIDS.
DISCLAIMER: Swiftech assumes no liability whatsoever, expressed or implied, for the use of this product, and more specifically for any, and all
damages caused by the use of this product to any other devices in a personal computer, whether due to product failure, leak, electrical shorts, and
or electro-magnetic emissions.
5. Filling up the radiator:
Simply remove the reservoir fill-cap, and fill-up the radiator with a
funnel. Adequate level is shown below:
DISCLAIMER: While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech® assumes no liability expressed or implied for any damage(s)
occurring to your components as a result of using Swiftech® cooling products, either due to mistake or omission on our part in the above instructions, or due to failure or defect in the Swiftech®
cooling products. In addition, Swiftech™ assumes no liability, expressed or implied, for the use of this product, and more specifically for any, and all damages caused by the use of this product to
any other device in a personal computer, whether due to product failure, leak, and electrical short, and or electro-magnetic emissions. WARRANTY: This product is guaranteed for 24 months from
the date of delivery to the final user against defects in materials or workmanship. During this period, it will be repaired or have parts replaced provided that: (I) the product is returned to the agent
from which it was purchased; (II) the product has been purchased by the end user and not used for hire purposes; (III) the product has not been misused, handled carelessly, or other than in
accordance with any instructions provided with respect to its use. This guarantee does not confer rights other than those expressly set out above and does not cover any claims for consequential
loss or damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as a consumer.