Swiftech MCR X20 DRIVE REV3 - Manual (Page 7)

Copyright Swiftech® 2011 – All rights reserved – Last revision date: 12-13-11 – One or more Patents Pending - Rouchon Industries, Inc., dba Swiftech® –151 West Victoria
St., Long Beach, CA 90805 – Toll free (US) 888-857-9438 – Tel. (310) 763-0336, Fax (310) 763-7095 - E Mail: [email protected] – URL: http://www.swiftech.com -
Information subject to change without notice – Page 7
the “alternate” configuration could for example be beneficial as follows:
• When cooling two CPUs, it might be desirable to parallelize them in order to maintain the exact same temperature for each CPU.
• For one of the quickest upgrades ever: one could get started with a CPU-only loop, and use the alternate configuration initially. Then when
installing additional water-blocks (graphics for example), all would be needed is to drain the liquid out, replace the plug(s) by fitting(s), and connect
the tubes to the new device(s). There is no need to remove the Apogee HD, no need to remove and recut tubes to length: the ex
isting loop doesn’t
need to be modified.
5. Filling up the radiator:
Simply remove the reservoir fill-cap, and fill-up the radiator with a
funnel. Adequate level is shown below:
DISCLAIMER: While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech® assumes no liability expressed or implied for any damage(s)
occurring to your components as a result of using Swiftech® cooling products, either due to mistake or omission on our part in the above instructions, or due to failure or defect in the Swiftech®
cooling products. In addition, Swiftech™ assumes no liability, expressed or implied, for the use of this product, and more specifically for any, and all damages caused by the use of this product to
any other device in a personal computer, whether due to product failure, leak, and electrical short, and or electro-magnetic emissions. WARRANTY: This product is guaranteed for 24 months from
the date of delivery to the final user against defects in materials or workmanship. During this period, it will be repaired or have parts replaced provided that: (I) the product is returned to the agent
from which it was purchased; (II) the product has been purchased by the end user and not used for hire purposes; (III) the pr oduct has not been misused, handled carelessly, or other than in
accordance with any instructions provided with respect to its use. This guarantee does not confer rights other than those exp ressly set out above and does not cover any claims for consequential
loss or damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as a consumer.