Installation guidelines – Swiftech MCRES 525 User Manual

Page 2

Advertising
background image

Installation guidelines

Figure 1: Always leave sufficient slack in the lines to pull enough
of the reservoir out of the drive bay and uncover the fill port.

Figure 2: You can start filling up the reservoir while it is in the drive
bay, using a household funnel. Then, start-up the pump and top-off
the reservoir as needed.
With this method, you will be able to fill-up
the reservoir to its minimum operating level, as shown figure 3.

Figure 3: The minimum operating fluid level is at the mould
parting line.

Figure 4: If possible or desired, you can also fill the reservoir outside
of the chassis. Tipping it steeply at an angle will allow you to fill-it up at
the maximum operating level as shown figure 5. Do not forget to close
the fill-cap before you re-install the unit into the drive bay!

Figure 5: Desired (Maximum) operating fluid level

Figure 6: Once full, secure the reservoir to the drive-bay with the
provided screws. Installation is complete!

IMPORTANT DISCLOSURES
While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech assumes no liability expressed or implied for
any damage(s) occurring to your components as a result of using Swiftech cooling products, either due to mistake or omission on our part in
the above instructions, or due to failure or defect in the Swiftech cooling products. WARRANTY Our products are guaranteed for 12 months
from the date of delivery to the final user against defects in materials or workmanship. During this period, they will be repaired or have parts
replaced provided that: (I) the product is returned to the agent from which it was purchased; (II) the product has been purchased by the end
user and not used for hire purposes; (III) the product has not been misused, handled carelessly, or other than in accordance with any
instructions provided with respect to its use. This guarantee does not confer rights other than those expressly set out above and does not
cover any claims for consequential loss or damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as
a consumer.

Copyright Swiftech 2004 – All rights reserved – Last revision date: 1-25-05
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

th

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:

[email protected] – URL:

http://www.swiftnets.com

- Information subject to change without notice

Advertising