Acoustic Research AW822 - Manual (Page 13)

Accessing the Speaker Battery Compartment
There are two options to power your wireless speaker: using the included AC power
adapter or using 8 C-cell batteries (not included). The Installation and Operation
Manual takes you through the steps to do both on page 5.
The Installation and Operation Manual does not include instructions for accessing
the battery compartment on the speaker.
To remove the speaker battery compartment
cover:
1. Lay the speaker gently on its top.
2. Use a Phillips-head screwdriver to loosen
the compartment cover screws.
3. Hold the battery compartment cover and
turn the speaker over. The screws should
fall out. If they don’t, lay the speaker on
its top again and loosen the screws a little
more.
Important: Don’t lose the screws! You’ll
need them to put the battery compartment
cover back on.
4. Put the speaker on its top again. Remove
the battery compartment cover.
5. Insert eight (8) C-cell batteries (not
included) in the speaker following the
polarity (+ and –) diagram inside the
compartment.
Speaker Battery
Compartment Cover
Cover
Screws
Speaker Bottom
To replace the speaker battery compartment cover:
1. Put the battery compartment back in place.
2. Put the screws back in the holes on the battery compartment cover. Use a
Phillips-head screwdriver to tighten the compartment cover screws.
Addendum to the Installation Manual
AW822_TIS2_00