Swiftech APOGEE XT MUTLI HDP 771 User Manual
Apogee, Xt – multi mount adapter plate
Copyright Swiftech 2009
– All rights reserved – Last revision date: 9-26-09 – One or more Patents Pending - Rouchon Industries, Inc., dba Swiftech® –151 West Victoria
Street, Long Beach, CA 90805
– Tel. 310-763-0336 - Toll free (US) 888-857-9438 – Fax 310-763-7095 - E Mail: [email protected] – URL: http://www.swiftech.com -
Information subject to change without notice
APOGEE
™
XT – MULTI MOUNT ADAPTER PLATE
INTEL 771 INSTALLATION GUIDE
– GUIDE D’INSTALATION – GUÍA DE INSTALACIÓN
Remove the stock hold down-plate
Using the provided Hex key loosen all 6 body screws, and set aside the
plate with its mounting screw springs.
Install the Multi-mount hold-down plate
Using the provided Hex key fasten the plate to the block with all 6 body
screws
Prepare the CPU
Clean the CPU with a degreaser (preferably formulated for electronics)
then apply the supplied grease to the center of the CPU.
Installation
For this installation, you will be keeping the existing motherboard
spring back-plate. Insert the 6-
32x1” Philips screws into the hold-down
plate holes that line up with the motherboard mounting holes, then slip
the nylon spacers into the screws, and finally thread in the nylon
retaining washers that conveniently hold the screw/spacer assembly
altogether
; you now have an assembly with four “posts”. Place the
waterblock on the CPU, and simply fasten the screws gradually and in
a cross pattern until the screws bottom out.
1
2
4
3