Swiftech S320 12KIT - Manual

S S 3 3 2 2 0 0 - - 1 1 2 2
power supply kit
installation guide
Bill of materials
Qty Item
1 S320-12 power supply installed in 5 ¼” adapter tray, screws
1 Electrical harness
1 Relay Switch
1 A/C socket adapter, stainless steel cover plate, screws
1 A/C cord
1 80mm fan guard with (8) snap rivets
Preamble
This kit has been designed to facilitate installation with as little modifications to the case as possible. It is however meant for advanced users,
well versed in installing computer components.
Specific tools needed to complete the
installation:
•
Power drill
•
1 ¼” (32mm) Bi-Metal hole saw to drill hole
for A/C socket
•
1/8” (3.0 mm) drill bit for A/C socket cover
mounting holes
•
Optional: 3 ¼” Bi-Metal hole saw, or jigsaw
to drill a 80mm blowhole above the power
supply fan exhaust; only necessary if
chassis does not have a blowhole already.
•
11/64” (4.5mm) drill bit for fan and/or fan
guard holes using the provided snap-rivets.
General Rules:
Always work on a bare case, removing side panels, front bezel, and top panel, with no power supply installed.
Never work with electricity connected to the computer while work is in progress.
Strip the case completely. Since you will be making holes in the case, metal debris could be flying off into your components, and a
bare chassis will be easier to clean-up.
1.
S320-12 Power supply installation
Install the power supply in the uppermost 5 ¼” bay slot as shown in figure 1. Use the provided screws to secure tray to the chassis.
It is essential to respect this requirement so as to provide adequate ventilation to the power supply.
Rouchon Industries, Inc., dbA Swiftech – 1703 E. 28 th St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All content
Copyright Swiftech 2002 – Last edited Dec 12, 2002 – Subject to revision without notice - 1 -
Figure 1