Spektrum SPM4010 DX4S - Manual (Page 14)

14 Spektrum DX4S • tranSmitter inStruction manual
EN
Dual ST (Dual Steering)
Trim: Act (Default) or Inh. We recommend activating the Trim, as it adjusts the trim for both the left and right steering servos. If you
need to make small adjustments to the individual servos, you can do so in the Sub-Trim menu.
Switch: You may assign the Dual ST mix to a switch, enabling a B Value in the mix. Assigning the Dual ST mix to a switch is valuable
when you want to assign dual steer values for different conditions. For example, you may use a smaller value when the vehicle is moving
faster. When the vehicle is moving slowly, use the switch to select the larger value and increase steering ability. You can also set one of
the mix values to 0% if you want to turn the mix off.
Brake Mix
Use the Brake Mix on large scale vehicles that require separate front and rear brake servos. The
mix value creates brake bias between the front and rear brakes. Assigning the Brake Mix to a switch
enables you to adjust the mix value from any screen.
1. Select AX1 or AX2 as the Slave channel. If Aux 1 or Aux 2 is assigned to another mix, it will not be
available as a Slave channel option.
2. Adjust the Brake Mix Value to establish the brake bias between the front and rear brakes. Switch:
You may assign the Brake Mix to a switch. Assigning the Brake Mix to a switch enables you to
adjust the brake bias from any screen.
Motor On Axle (MOA) Throttle Mix
The MOA Throttle Mix is used to adjust the throttle bias on rock crawlers using a “motor on axle” configuration.
Mix options:
• Rear Dig
• Front Dig
• 4WD
1. Select MOA from the Throttle Mix menu.
2. Scroll to Inh. Press the scroll wheel, then scroll to activate the mix. Press the
scroll wheel again to adjust the mix.
3. To inhibit an option
Scroll to the MOA option, then select Inh. All MOA options are active by
default. If you inhibit an option, the Mix switch ignores the option.
4. Adjust the Throttle Bias value (4WD Only)
The value shown on the screen is a percentage of the rear motor rate.
For example, a value of “70%” means the rear motor power is 70% of the
front motor power.
5. In Motion Adjustment
You can assign the throttle bias to the following switches:
Assigning the Throttle Bias to a switch enables you to adjust the throttle bias
while the vehicle is moving.
6. Assigning the Mix Options to a Switch
Assign the MOA Options to a switch. Each time you move the Mix switch, the
MOA options appear on the Main Screen.
Bias Step:
The Bias Step affects the amount the mix changes with each click of the button or
dial but has no effect on the total mix range.
Main Screen MOA Mix Screen
• A
• B
• C
• D
• E
• Dial