Spektrum SPM3300 DX3C Manual - Manual (Page 12)

12 Spektrum DX3C • Radio Instruction Manual
EN
Copy
The Copy function shares active model memory settings with a
selected model memory space. This is useful for saving setups
for one model to adjust programming for track conditions or
model setups.
A Choosing No returns to the List Screen
B Name of destination model memory
C Name of active or source model memory
D Active or source model memory number
E Destination model memory number
F Box shows selected text
G Choosing Yes saves active model settings to the selected
model memory
CAUTION: Model information saved in a memory is
erased and overwritten by active model settings using
this Copy function.
System
The System function lets you adjust transmitter interaction.
Selections affect all saved model memories.
A Username
You can program a user name with up to 10 characters. This
name shows on the Main Screen. User name defaults to
Spektrum.
In the System screen highlight the User Name and press the
roller to access the function. Use the roller to select the position,
then press the roller to access a character.
B RS Port
This sets the port (
Bind or Aux (Auxiliary) on the receiver for
ROSS (Losi Remote Onboard Starting System) connection.
C Alert
You can set an alarm to sound when the battery voltage gets to
the limit set with the Alert. The range which can be set is from
0.0V to 6.2V. Battery voltage shows on the Main Screen.
CAUTION: Do not operate a model when the battery
voltage is below 4V.
D Contrast
The contrast function provides adjustment to the brightness ratio
of the lightest to the darkest part of the screen. You can set the
contrast to a value from 0 to 30 (0 is lightest and 30 is darkest).
E Buzzer
You can adjust sounds in loudness among
Off, Low and High.
Note: Buzzer adjustment does not change sound level for
Inactivity or Low Battery warnings.
F Lang (Language)
You can select English, German (Deu.), French (Francais) or Ital-
ian (Italiano) as the language showing on transmitter screens.
G RF Mode
You can set this mode on either Std or FR. Std is the standard
RF mode. FR is the France RF mode and should only be selected
when the transmitter is used in France.
H About....
This shows the release level of the transmitter’s software. Refer
to Memory Card instructions for updating transmitter software.
I
A small bar shows relative position of highlighted screen name
in the list.
System
Username
RS Port:Bind
Alert:4.1V
Contrast:20
Buzzer: Off
E
D
C
B
A
H
G
F
System
Contrast:20
Buzzer: Off
Lang:English
RF Mode:Std
About... I
System
Username
RS Port:Bind
Alert:4.1V
Contrast:20
Buzzer: Off
E
D
C
B
A
H
G
F
System
Contrast:20
Buzzer: Off
Lang:English
RF Mode:Std
About... I
Copy
From: 1
NAME-O1
To : 3
NAME-O3
No Yes
A
G
F B
C
D
E