AEG 1400 D - Manual (Page 4)

45
Introduction
Extractor version
• The hood is supplied as an extractor unit and can also be used with
a filtering function by fitting one charcoal filter (special accessory).
• You will need original AEG charcoal filter for this function (see
Special Accessories).
• The unit features two outlet holes, one of which A is located on the
top of the unit while the other B is located on the rear.
• To connect up the hose, you should first fit the bayonet-mounting
flange C (Ø 120 mm) on the outlet required (if using the top outlet, fix
the flange in place using the screw supplied as shown in Fig. 1).
Close off the unused hole using the bayonet fitting caps D.
• Warning! If is decided to use the rear outlet hole B, first remove the
sponge E that closes that hole. Fig. 2.
Fig. 1
Filter Version
• The air is filtered and recirculated
through the front grid.
• Move the lever G to position F -
Fig. 3.
• You will need an original AEG
KF14 charcoal filter for the filtering
function. (See Special
Accessories).
Fig. 2
Fig. 3