Ampro Corporation Ampro ReadySystem 1U - Manual (Page 16)

Chapter 2 Installing ReadySystem 1U Options
12 Users Guide ReadySystem 1U
7. Disconnect all of the remaining cables from the ReadyBoard, before continuing. See Figures 2-4,
2-5, and 2-6.
To remove the ReadyBoard from the enclosure with greater freedom, you may find it necessary
to disconnect any cables between the +5 volt regulator and the internal parts of the ReadySystem.
Refer also to the respective ReadyBoard QuickStart Guide for more cable removal information.
8. Remove all screws (8) holding the ReadyBoard to the enclosure standoffs. See Figure 2-5.
9. Slowly work the ReadyBoard to the rear of the enclosure until it is safely clear and place it on a
protective surface. See Figure 2-5.
Place the ReadyBoard on a protective surface for SODIMM removal/replacement.
R
d
y
S
y1U
_09a
b
M3x0.5 Screws (8)
6 mm thread length
with washers and
lock washers ReadyBoard
Note: All standoffs have a
thread size of M3x0.5
and accept M3x0.5 screws
Figure 2-5. Removing ReadyBoard from Enclosure
Installing the ReadyBoard into the Enclosure
1. Prepare the ReadySystem for ReadyBoard installation.
♦ If the ReadySystem is already prepared for ReadyBoard installation with the top cover
removed, a SODIMM installed, and the coaxial power cable disconnected, skip to Step 6.
This includes installing the correct size SODIMM onto the ReadyBoard, since you will not
have access to the SODIMM socket once the ReadyBoard is installed into the ReadySystem.
♦ If the ReadySystem is not ready for the ReadyBoard installation, continue with the next step.
CAUTION To prevent damage to the ReadyBoard, ensure the coaxial power cable
has been removed from the DC IN connector of the I/O panel and the
AC-DC adapter has been disconnected from the AC power source.