Troubleshooting, Power, display, settings issues – Nikon AW120 User Manual
Page 239
F
9
T
e
chni
cal N
o
te
s
a
n
d I
n
dex
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon-authorized service
representative.
Power, Display, Settings Issues
Troubleshooting
Problem
Cause/Solution
A
The camera is on but
does not respond.
• Wait for recording to end.
• If the problem persists, turn the camera off.
If the camera does not turn off, remove and
reinsert the battery or batteries or, if you are
using an AC adapter, disconnect and
reconnect the AC adapter.
Note that although any data currently
being recorded will be lost, data that have
already been recorded will not be affected
by removing or disconnecting the power
source.
–
Battery inserted in the
camera cannot be
charged.
• Confirm all connections.
• When connected to a computer, the
camera may not charge for any of the
reasons described below.
- Off is selected for Charge by computer
in the setup menu.
- Battery charging stops if the camera is
turned off.
- Battery charging is not possible if the
camera’s display language and date and
time have not been set, or the date and
time were reset after the camera’s clock
battery was exhausted. Use the charging
AC adapter to charge the battery.
- Battery charging may stop if the
computer is in sleep mode.
- Depending upon the computer
specifications, settings, and status,
battery charging may not be possible.
–
–
–
Camera cannot be
turned on.
• The battery is exhausted.
• The power switch is enabled a few seconds
after the battery is inserted. Wait a few
seconds before pressing the power switch.
–