American Audio VersaPort - Manual (Page 2)

Thank you for purchasing this
©
American Audio
®
product. Please read the following instruc-
tions before installing or using your new unit.
The
©
American Audio
®
Versaport is a great way to convert any analog signal into digital files. It's
practicality to conncect to a PC and Mac is due to GigaPort, which supports ASIO 2.0. This easy-
to-use audio interface connects directly to your PC, Mac, or anything with a USB port. Record audio
with your computers built-in audio recorder or your favorite audio production software (please see
software recommendations on the last page).
(RCA cables not included)
seT UP: Please make sure you computer is compatible with the system requiremnets listed on page
4.
1. Install your desired software into your computer. Please use one of the software programs listed
on page 4.
2. Connect the Versaport to an available USB port on your computer using the Versaport's attached
USB cable.
3. Connect your desired sound equipment; record player, CD/Mp3/WMA player, mixer, effect player,
cassette deck or radio, to the RCA input jacks on the Versaport. You can connect a microphone to
the mic input jack on the Versaport.
You can connect headphones to the headphone jack and adjust the volume using the Headphone
Volume knob.
Note: You can only connect a record player to Input 2. When a record player is connected to
Input 2 the Line In/Phono switch must be in the phone position (pushed in).
4. Using the Versaport’s RCA output jacks you can connect to a amplifier, mixer, sound effect
machine, or speakers with a built-in amplifier.
To adjust the Input recording volume:
Open the Audio properties in your computer and select Recording. Adjust the “Wave In” to your
desired level.
VersAPorT InTrodUcTIon And seT UP
© American Audio ® - www.americanaudio.us - Versaport Instruction Manual Page 2