Nikon COOLPIX-P100 - Manual (Page 198)

186
Error Messages
T
ec
hni
cal
No
tes an
d
In
d
ex
N
Press the flash pop-up
button to raise the flash.
The built-in flash is not
raised during the
Night portrait or
Backlight scene
modes.
Press the m (flash pop-up) button to
raise the built-in flash.
35, 47,
51
N
The flash is lowered.
The built-in flash is not
raised during the
scene auto selector
mode. Press the X (flash pop-up) button to
raise the built-in flash. The camera can
still shoot normally with the flash
lowered if you do not wish to use it.
35, 43
N
Lower the flash.
The built-in flash is
raised when recording
a movie. Lower the built-in flash gently and
shoot a picture. Note that sound of
lowering the flash may be recorded.
35, 127
Q
Lens error. (If the lens cap
is attached, turn the
camera off, remove the
lens cap, and turn the
camera on.)
Lens error
Remove lens cap if it is still attached,
and turn the camera off and then on
again. If the error persists, contact
retailer or Nikon-authorized service
representative.
21
P
Communications error
Error occurred during
communication with
printer.
Turn off camera and reconnect cable.
141,
147
System error
Q
Error has occurred in
camera’s internal
circuitry.
Turn off camera , remove and reinsert
battery, and turn on camera. If the
error persists, contact retailer or
Nikon-authorized service
representative.
21
PR
Printer error: check
printer status.
Printer error
Check printer. After solving the
problem, select Resume and press
the
k button to resume printing. *
-
PR
Printer error: check paper Specified size of paper
is not loaded in printer.
Load the specified type of paper,
select Resume and press the
k
button to resume printing.
*
-
PR
Printer error: paper jam Paper has jammed in
the printer.
Remove the jammed paper, select
Resume and press the
k button to
resume printing.
*
-
PR
Printer error: out of paper No paper is loaded in
the printer.
Load the specified type of paper,
select Resume and press the
k
button to resume printing.
*
-
PR
Printer error: check ink
Ink error
Check ink, select Resume and press
the
k button to resume printing. *
-
Display Description Solution A