Nikon Coolwalker - Manual (Page 15)

5
Pr
ep
ar
at
io
n
—
Pa
rts
o
f t
h
e C
O
O
LW
A
LK
ER
M
SV
-0
1
Before Using the Remote Control Unit Remove the Insulating Tape.
Remote Control Unit
The remote control unit is shipped with an insulating tape in the battery
holder. Before using the remote control unit remove the insulating tape,
pulling it in the direction indicated by the arrow.
Inserting the CR2025 Lithium Battery
1. Press the latch inwards ( ➀ ) and pull out the battery holder ( ➁ ) at the base of the remote
control unit in the direction indicated by the arrow in the illustration.
2. Place the battery in the battery holder ( ➂ ).
3. Insert the battery holder into the remote control unit. Push it in until the latch locks in place ( ➃ ).
Power OFF button
(
10)
Left function button
(Left button)
(
6)
Multi selector
(
6)
Battery holder (CR2025 lithium battery)
Remote control transmitter
Rotate button
Right function button
(Right button) (
6)
Enter button
(
6)
Insulating
Tape
Make sure that the positive (+) side of the battery
is in correct orientation as indicated on the back
of the remote control unit.
➀
➁
➂
➃
Battery holder latch