Nikon P330 User Manual
Page 230
F8
Troubleshooting
Tec
h
nica
l N
otes and
Ind
e
x
Monitor is blank.
• Camera is off.
• Battery is exhausted.
• Standby mode for saving power: Press the power switch,
shutter-release button,
c button or b (e movie-record)
button, or rotate the mode dial.
• When flash lamp flashes, wait until flash has charged.
• Camera and computer are connected via USB cable.
• Camera and TV are connected via audio/video cable or HDMI
cable.
• Interval timer shooting in progress.
Monitor screen is
hard to see.
• Adjust monitor screen brightness.
• Monitor is dirty. Clean monitor screen.
Date and time of
recording are not
correct.
• If the camera clock has not been set (“Date not set” indicator
flashes during shooting), still pictures have a time stamp of
“00/00/0000 00:00”; and movies are dated “01/01/2013 00:00.”
Set the correct date and time using Time zone and date in
the setup menu.
• The camera clock is not as accurate as a normal clock, such as
watches. Check camera clock regularly against more accurate
timepieces and reset as required.
No information
displayed on the
monitor.
Hide info is selected for Photo info of Monitor settings in the
setup menu.
Print date not
available.
Time zone and date in the setup menu has not been set.
Date not
appearing on
pictures even
when Print date is
enabled.
• A shooting mode that does not support print date is selected.
• Another function that is set now is restricting the print date.
• The date cannot be imprinted onto a movie.
74
–
Screen for setting
time zone and
date is displayed
when camera is
turned on.
Clock battery is exhausted; all settings were restored to their
default values.
Camera settings
reset.
Reset file
numbering
cannot be done.
Reset file numbering cannot be applied when the folder
number reaches 999 and there are images in the folder. Change
the memory card, or format the internal memory/memory card.
Monitor is turned
off, and the power-
on lamp flashes
quickly.
Battery temperature is high. Turn off camera, and allow battery to
cool down before resuming use. After the lamp flashes for 3
minutes, the camera turns off automatically, but you can also
press the power switch to turn it off manually.
Problem
Cause/Solution
A