Nikon D5100 - Manual (Page 59)

41
z
D
The AF-Assist Illuminator
If the subject is poorly lit, the AF-assist illuminator will light
automatically to assist the autofocus operation when the shutter-
release button is pressed halfway. The AF-assist illuminator will not
light:
• In live view or during movie recording
• During manual focus or if live view is off and continuous-servo
autofocus is selected (AF-C selected for focus mode, or
continuous-servo AF selected in AF-A focus mode)
• If the center focus point is not selected in c (Single-point AF), d (Dynamic-area AF),
or f (3D-tracking (11 points)) AF-area mode (0 42, 43)
• In shooting modes in which the AF-assist illuminator can not be used ( 0 216)
• If Off has been selected for Custom Setting a2 (Built-in AF-assist illuminator; 0 158)
The illuminator has a range of about 0.5–3.0 m (1 ft. 8 in.–9 ft. 10 in.); when using the
illuminator, use a lens with a focal length of 18–200 mm and remove the lens hood. The AF-
assist illuminator will turn off automatically to protect the lamp after a period of continuous
use. Normal function will resume after a brief pause. Note that the illuminator may become
hot when used multiple times in quick succession.
A
See Also
For information on focusing in live view, see page 100. For information on using release
priority in continuous-servo AF, see Custom Setting a1 (AF-C priority selection,
0 158).
Custom Setting d1 (Beep; 0 161) can be used to turn the beep speaker on or off.
AF-assist illuminator