Indesit FIMU23WH - Manual (Page 23)

GB
23
If Something Goes Wrong?
Before calling a Service Engineer, please check through the following lists.
THERE MAY BE NOTHING WRONG.
Problem Check
Slight odour or small amount of
smoke when grill/oven is used
for the first time.
This is normal and should cease after a short period.
Nothing works.
If you find :-
Display is blank.
Then it is likely that there is no electricity supply to your oven.
Check:
(i) That the main cooker wall switch is turned on.
(ii) Check other appliances to see if you have a power cut.
(iii) Check the main circuit breaker for the property.
Timer Display "
0.00
AUTO"
The power supply to your oven has possibly been interrupted, but has now come
back on again. Reset the timer to the correct time of day and "Manual" operation
using the instructions given in the timer section of the book.
Main Oven does not work,
but the Grill and Top Oven
work.
Check the following to ensure that the timer is in Manual Mode:
Check that the Auto Symbol is not lit up and is not flashing.
See timer section for instructions on how to return timer to "Manual".
Top Ovens and Grill do not
work, but the Main Oven works.
Operating the cooker under the following conditions may cause a safety device to
operate.
(a) Grilling with the door closed - always grill with the door open to the correct
position - see grilling
(b) Grilling for an excessively long period at maximum setting - see grilling guide.
(c) Grilling with inadequate ventilation in the cabinet - see installation instructions.
Grill keeps turning on and off
When the "Grill" control (A) is operating at less than MAX, the grill will cycle on and
off, this is normal and is not a fault.
Can not set an "Auto Cook"
programme
Remember: "Cook Period" is the actual length of time for which, the timer will switch
the oven(s) on as part of an "Auto Cooking" programme.
Draught from beneath control
panel.
A gentle flow of air will be blown from beneath the control panel when the appliance
is used. If the appliance is still warm, this cooling fan may run on, or restart itself after
all of the controls have been turned off. The fan will stop once the appliance has
been cooled. This is normal and not a fault.
Timer buzzer/bleeper operates
continually
Press the minute minder button to silence the Buzzer/Bleeper.
If you have been through the above list and there is still a problem, contact Service (see Back Page).