Indesit TK64SIX - Manual (Page 13)

GB
Installation
 Before operating your new appliance please read this
instruction booklet carefully. It contains important
information concerning the safe operation, installation
and maintenance of the appliance.
 Please keep these operating instructions for future
reference. Pass them on to any new owners of the
appliance.
Positioning
 Keep all packaging material out of the reach of
children. It may present a choking or suffocation hazard
(see Precautions and tips).
 The appliance must be installed by a qualified
professional in accordance with the instructions
provided. Incorrect installation may damage property or
cause harm to people or animals.
Built-in appliance
Use an appropriate cabinet to ensure that the appliance
operates properly.
• The supporting surface must be heat-resistant up
to a temperature of approximately 100°C.
• If the appliance is to be installed above an oven,
the oven must have a forced ventilation cooling
system.
• Avoid installing the hob above a dishwasher: if
this cannot be avoided, place a waterproof
separation device
between the two
appliances.
• Depending on the
hob you want to install,
the cabinet must have
the following
dimensions (see
figure):
Ventilation
To allow adequate ventilation and to avoid overheating
of the surrounding surfaces the hob should be
positioned:
• At a minimum of 40 mm from the back panel and
600 mm from any
other vertical
surfaces.
• So that a
minimum distance
of 10 mm is
maintained
between the
installation cavity
and the cabinet
underneath.
Fixing
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could alter
the features and the operation of the hob.
560 +/- 1
490 +/- 1
48
590
520
FRONT SIDE OF HOB
30
40
SUPPORTING
SURFACE
UNDERSIDE OF HOB
40 mm min.
40mm
Opening of at least 5 mm
on the overall width
measurement of the surface.
Above an empty cabinet or a drawer
A space of at least 40 mm, or an opening of 5 mm on
the width measurement of the cabinet, should be created.