Not for reproduction, Warning – Axion ZT2142 User Manual

Page 32

Advertising
background image

BRAKE ADJUSTMENT

1. Stop the unit, turn the ignition OFF, set the ground

speed levers to START/PARK positions, set the
parking brake lever to the ENGAGE position, and wait
for all moving parts to stop.

2. Locate the brake rod (A, Figure 46) and adjustment

nut (B).

3. Measure the parking brake spring. Its compressed

length, with the parking brake lever in the ENGAGE
position, should be 3-1/2” (8.89cm). Adjust the spring
length by turning the adjustment nut (B), if necessary.

WARNING

Figure 46. Brake Adjustment
A. Brake Rod
B. Adjustment Nut
C. Return Spring (Removed for Illustration Only)
D. Return Spring Hole

3-1/2" (8.89cm)

A

B

C

D

Corrosion hazard.

Batteries contain acid. Always keep the
battery upright and do not spill the
electrolyte. Avoid contact with skin and
eyes.

Explosion hazard.

Changing the battery produces explosive
hydrogen gas. Only charge the battery in a
well ventilated area, away from any ignition
source such as a water heater, electric
motor, or a lit cigarette.

Wear Protective Equipment

Always wear gloves and safety glasses
when handling the battery and battery
cables.

BATTERY CHARGING

A dead battery or one too weak to start the engine may
be the result of a defect in the charging system or other
electrical component. If there is any doubt about the
cause of the problem, contact your local dealer. If you
need to replace the battery, follow the steps under
Cleaning the Battery & Cables in the Regular
Maintenance Section.

To charge the battery, follow the instructions provided by
the battery charger manufacturer as well as all warnings
included in the safety rules sections of this book. Charge
the battery until fully charged (until the specific gravity of
the electrolyte is 1.250 or higher and the electrolyte
temperature is at least 60° F). Do not charge at a rate
higher than 10 amps.

ENGINE ADJUSTMENTS

The engine is designed to deliver the correct
performance under all operating conditions. Any
adjustments must be performed by your local authorized
dealer.

32

Not

for

Reproduction

Advertising
This manual is related to the following products: