Aga Ranges Fired Earth Underfloor Heating - Manual (Page 6)

Ancillary Products
A full range of high quality fixing and
sealing products, researched and developed
to meet Fired Earth standards, are available
for both professional and DIY use.
Website
- www.firedearth.com
All our installation guides are available
to download from our website.
Useful Numbers
UK Sales 0845 366 0400
Export Sales +44 (0)1295 814316
Installations 01295 814310
Technical 01295 814271
Home Deliveries 01295 814313
Other Guides Available
Wall Tiling, Floor Tiling,
Wood Flooring and Waterproofing
Showers and Bathrooms.
Disclaimer
The specifications and technical information given
in this publication are intended for guidance and
although they are to the best of our knowledge correct,
they are given without warranty.
We cannot accept any responsibility for reliance placed
upon the advice contained herein since practical
expertise and site conditions are outside of our control.
Neither do we accept liability for the performance of
the product arising from such use. This does not affect
your statutory rights.
Fired Earth is a trading name of Aga
Consumer Products Limited. Registered
in England and Wales under Registered
Number 3872754. Registered Office
Address - 4 Arleston Way, Shirley,
Solihull B90 4LH.
Glossary
BTU’s - (British Thermal Units) the
measurement used to calculate the required
heat for a particular room to reach the
recommended temperature. The heat
source/s within a room must provide this
amount of heat as a minimum.
Guarantee – 10 years for the mats provided
installed correctly and not physically
damaged 1 year for any electronic
controls/switches etc
IEE – Institute of Electrical engineers
Insulation – a product which prevents
heat loss, but which must be sufficiently
rigid for tiling
Programmable Thermostat – reading the
temperature of the air or the floor
depending on the chosen system, the
thermostat can be programmed to switch
the system on and off by time and also
by temperature.
RCD – residual current device –shuts of the
supply when a fault is detected reducing
the risk form electric shock
Sole source heating – it is not always
possible to sufficiently warm all rooms at
all times of the year with this type of
heating. Various specifications of the
room/s to be heated will be required to
confirm the required BTU’s and therefore if
sufficient quantities of the mats can be
installed to produce the heat required.
Watts – measurement of energy, 1000
watts is equivalent to 1kw.
10