ATEN ATEN Petite CS-64U - Manual (Page 12)

Hotkey Setting Mode
Hotkey Setting Mode is used to set up your CS-64U switch
configuration. All operations begin with invoking Hotkey Setting
Mode (HSM).
Invoking HSM
To invoke HSM do the following:
1. Press and hold down the Num Lock key
2. Press and release the minus key
3. Release the Num Lock key
Note: The minus key must be released within one half second,
otherwise Hotkey invocation is canceled.
When HSM is active, the Caps Lock, and Scroll Lock LEDs
flash in succession to indicate that HSM is in effect. They stop
flashing and revert to normal status when you exit HSM.
Ordinary keyboard and mouse functions are suspended - only
Hotkey compliant keystrokes and mouse clicks (described in
the sections that follow), can be input.
At the conclusion of some hotkey operations, you automatically
exit hotkey mode. With some operations, you must exit manually.
To exit HSM manually, press the Esc key, or the Spacebar.
Alternate HSM Invocation Keys
An alternate set of HSM invocation keys is provided in case the
default set conflicts with programs running on the computers:
1. Invoke HSM (see above)
2. Press and release the H key
The HSM invocation keys become the Ctrl key (instead of Num
Lock) and the F12 key (instead of minus).
Note: This procedure is a toggle between the two methods. To
revert back to the original HSM invocation keys, invoke
HSM, then press and release the H key again.
- 10 -
2004-06-10