ROTHENBERGER Universal ROTIGER VARIO Electronic - Manual (Page 16)

15 ENGLISH
The machine is designed that the blade could
be mounted or removed without a wrench or
any other tools.
1. Press the switch and the shaft will move
forward. Then turn off the switch and unplug
the power cord.
2. Please turn the quick-release collar as
shown.
3. Turn the quick-release collar to insert the
blade into the small slot of the shaft. The
blade could be mounted either in the upward
or downward direction. When you release the
quick-release collar, the spring will return
automatically.
4. Pull the blade forth and back for several
times by hand to ensure the blade clicks.
5. Sometimes you need to turn the quick-
release collar as shown to ensure the blade
is mounted appropriately when there is dust
or dirt accumulated on the quick-release
collar.
Removing the blade
WARNING: Make sure to unplug the power
cord when mounting or removing the blade.
1. Press the switch and the shaft will move
forward. Then turn off the switch and
unplug the power cord.
2. Turn the quick-release collar as shown.
WARNING: Never touch the blade with bare
hands after cutting. The blade is often very
hot after cutting and may result in personal
injury.
WARNING: Never use the saw if the fixing slot
of the tip of the blade is damaged.
When the blade is broken If the blade is broken
and remains in the shaft, turn the quick-release
collar and the broken part will fall out. If not, use
a tip of another blade to take it out.
Use compressed air to clean the accumulated
chips on the quick-release collar.
Lubricate the quick-release collar regularly to
prevent from rusting.
WARNING: NEVER TOUCH BLADE
IMMEDIATELY AFTER USE, AS IT MAY BE
HOT ENOUGH TO CAUSE SEVERE BURNS.
TO PREVENT ACCIDENTAL ELECTRICAL
SHOCK THE SAW MUST BE HELD WITH ONE
HAND ON THE MAIN HANDLE AND THE
OTHER HAND ON THE RUBBER GEARCASE
COVER. THE RUBBER GEARCASE COVER
MUST BE FREE OF DAMAGE AND
PROPERLY INSTALLED AT ALL TIMES.
Adjusting the shoe plate
If some of the teeth of the saw blade is worn out,
use a hex wrench to adjust the position of the
shoe plate. Tighten the screw after the
adjustment.
TO START AND STOP SAW
1. Make sure power circuit voltage is the
same as shown on the specification plate
on the saw. Connect saw to power circuit.
2. Hold saw firmly. Squeeze trigger switch to
start motor.
3. Release trigger to stop motor.
D-Handle Models only:
D-handle models also have a Lock Button. To
lock the switch in the on position, press the lock
button while the switch is fully on. To release the
lock, press the switch and release it.