A.J. Antunes & Co MS-255 9100468 - Manual (Page 14)

Miracle SteaMer
14 P/N 1010455 Rev. D 03/12
A.J. Antunes & Co.
figure 12. inlet hose assembly
male Quick
Disconnect insert strainer cup
tubing
checKinG anD cleaninG the water strainer
the Water strainer protects your equipment from any
foreign debris in the water line that could get into the
food or damage the unit’s solenoid and cause the unit
to leak or flood. it also protects the equipment’s proper
and consistent operation from interference.
to ensure proper and consistent steaming results,
check the Water Pressure Regulator and strainer
cup regularly. if the pressure has dropped, check the
strainer cup and clean out the accumulated debris as
follows.
1. shut off the water supply valve to the unit,
unscrew the clear, plastic strainer cup and care-
fully remove the Mesh screen.
2. at the sink, gently flush all of the accumulated
debris from the strainer cup and Mesh screen.
be especially careful not to damage the Mesh
screen.
maintenance (continued)
mesh
screen
O-ring
3 carefully place the Mesh screen into its seat at
the bottom of the strainer cup and confirm that
the orange O-ring is properly seated in its place
before screwing the strainer cup and top back
together.
4. Purge the air out of the strainer and tubing by
disconnecting the Male Quick Disconnect insert
from the equipment and, over a bucket, push the
white plastic tip in until there is good water flow.
5. Replace damaged or worn parts as needed.
6. Verify that the Water Pressure Regulator is set to
20–25 psi (1.4–1.7 kg/cm2 or 138–172 kPa).