A.J. Antunes & Co TTS-8 9900629 - Manual (Page 3)

Display Description
This section describes the Timer display and the various
functions available on the Timer. Refer to Figure 1 to
identify the different locations of these features.
Function/
Area
Description
Channel
Selection
Buttons
Press a Channel Selection button to start
a pre-programmed cycle, view a cycle (if
actively timing), or program a desired
channel for a time cycle.
Active Channel
Display
Indicates the channels currently timing.
Channel
Display
Indicates the number of the timing chan-
nel that is counting down in the Time/Data
display.
Time Display Displays the time remaining for the chan-
nel closest to completion (unless otherwise
selected).
Timing Stage Indicates the active Timing Stage (blank for
single stage cycles).
Up/Down Arrow
buttons
Used to increase or decrease desired
cooking times. Also used to select desired
Cooking Stage. Used only in programming.
Enter button Stores the selected time into memory. Used
only in programming.
A. J. ANTUNES & CO. 180 Kehoe Blvd., Carol Stream, Illinois 60188
NOTE: The timer contains three AA Alkaline batteries
to boost beeper volume. The batteries should last
approximately one year. If the beeper volume begins
to get too low, replace the batteries. The timer WILL
operate normally without the batteries.
If the batteries run low on power, the timer will dis-
play a “
Lo BaT ” alert only when the timer is idle.
This message will appear for 3 seconds and reappear
every 30 seconds.
To replace the batteries in Mfg. No. 9900624 &
9900628, open the side battery cap and install three
(3) new AA batteries, and close the side battery cap.
To replace the batteries in Mfg. No. 9900630, 9900632,
9900643, 9900644, & 9900645 unscrew battery lock
on side of unit and install three (3) new AA batteries,
then replace battery lock.
Problems with the Timer?
If you experience any problem with your TimeTech Timer,
contact the manufacturer immediately at 877-392-7854
(Toll Free in the U.S. and Canada) or at 630-784-1000
(outside the U.S and Canada).
Cleaning the Timer
To clean the timer, wipe it lightly using a clean, dry towel.
Do NOT submerse the timer in water. Do NOT wash it in
a dishwasher. Doing so will void the warranty.
1-877-392-7854 Fax: 630-784-1650 Page 3 of 4 1010878 Rev. G 08/12