HID EDGE EVO EIM-M Hi-O Input Module Installation Guide - Manual

Specifications
CONDITIONS VOLTAGE DC (VDC) CURRENT (Amp) OPERATING
TEMPERTURE
CABLE LENGTH
UL REFERENCE
NUMBER
Inputs
DC Input (NSC) 10.8 - 24VDC 0.03Amp
32° - 122°F
(0° - 50° C)
Input Circuits
500 ft (150 m)
= 22 AWG ● 0.65mm ● 0.33mm 2
18 AWG ● 1.02mm ● 0.82mm 2
Hi-O CAN Bus Total Length 100 ft (30 m) -
22 AWG ● 0.65mm ● 0.33mm 2
Maximum between drops 30 ft (10 m)
22 AWG ● 0.65mm ● 0.33mm 2
MEIMAxNN
X = K for Black
G for Gray
DC Input (MAX) 10.8 - 24VDC 0.04Amp
Supervised Inputs (MAX) 0 to 5VDC Reference 0.005 (Sink)
NSC = Normal Standby Condition
Note: The EdgeModule Input device senses changes in other devices.
Wiring
Input 1 Input 2
10 P3 1
Hi-O Group Select Jumper
Short = Group 1, Open = Group 2
Outside Door Inside Door
( )
4 P1 1
* *
- +
Input 3 Input 4
- + - + - +
* Internal Optical Tamper Disable Jumper
CAN V+
GND
CAN H
CAN L CANbus
Internal Optical Tamper
To disable the internal optical tamper sensor, attach a jumper wire from P3 pin 1 to P3 pin 2.
Note: If desiring an external tamper, wire an unsupervised Normally Closed contact, and replace the jumper.
EDGE EVO
®
Input Module
EIM-M
I
nstallatIon
G
uIde
82340-901, Rev B.1
October 2011
© 2011 HID Global Corporation. All rights reserved.
15370 Barranca Parkway
Irvine, CA 92618-2215
USA
Optional
Supervised Inputs
1-6K
N/O
1-6K
N/C
1-6K
1-6K
N/O
Designed for interfacing to general purpose inputs typically not associated with
standard access point control, the Input Module provides an interface to four input
analog/digital inputs. The module is always configured as general purpose input.