HID Wiegand PINPad Rev D Installation Guide - Manual

9292 Jeronimo Road
Irvine, CA 92618
Tel.: (949)-598-1600
Fax: (949)-598-1690
PINpad™ Wiegand Reader
Single-Gang box 26-bit Wiegand Reader
with Keypad
Model 32788
INSTALLATION GUIDE - 7393800, REV D
October 19, 2007
Overview
The Wiegand PINpad is a Wiegand reader and keypad
combined in the same rugged housing. It is fully sealed
against the environment and the wide operating
temperature range makes it ideal for Indoor-Outdoor use,
even under the most extreme conditions. The Wiegand
PINpad mounts easily to standard electrical hardware, such
as a single-gang box, and the attractive appearance makes
it a welcome addition to any location.
The unique design of the Wiegand PINpad transmits both
card and keypad data over the Wiegand lines, eliminating
the need to pull separate wiring for each device.
The Wiegand PINpad is ideal for Access Control, Time and
Attendance or other applications where Wiegand card data
and/or Keypad data is required. For Access Control
applications you can use just the keypad during low
security periods, the Wiegand reader during high security
periods or both for maximum security.
There is no need to cut two wall openings as both the reader and keypad are combined.
Additionally, the Wiegand PINpad transmits data using Wiegand output making it a direct
replacement
* for your existing Wiegand output hardware.
*The Wiegand PINpad may have a higher current draw than the existing equipment. Make sure that the existing wiring and
panel are capable of the increased current requirement.
Output
The Wiegand PINpad transmits data over the D0 and D1 lines in accordance with the
Wiegand output format (see Wiegand Reader Output). The binary code embedded within
a Wiegand card is read when the card is properly swiped and sent directly from the
reader, the reader performs no calculation on the card data.
Personal ID numbers (PIN) are entered in the keypad. Once a valid number is entered
and the # key is pressed, the PINpad sends the PIN number as a HID 2601 format data
stream. The algorithm is described in detail in the Keypad Data section.
The Hold Line allows users to store card data. If, while card data is stored, another card is
“swiped” the new card data will replace the stored card data. Keypad data is always sent
directly to the D0 and D1 lines.